Zenith / LG 6913V00002A How To Guide Replacement DLP Lamp Guide

Click below to buy this lamp now:

Lowest Prices Anywhere!

Modelos compatibles: D52WLCD, D60WLCD, E44W46LCD, E44W48LCD, M52W56LCD.

NORMAL DISCLAIMER:
— Do NOT purchase generic brand lamps such as LTI, APO or third-party manufacturers such as OSRAM. These lamps were NOT engineered with and for your TV…only your Philips lamp has been engineered to work flawlessly and output the best possible color. Above that, it just doesn’t make sense to choose an aftermarket lamp for a $5-$10 difference (and in many cases they are more expensive!!).

Be a smart consumer and shop around, do your research! Discount-Merchant.com promises to be the low price leader in all Projection Lamps they carry…if this is not true, let us know and we’ll fix it!

Tools Required: 1 Phililps screwdriver, 1 Pair of Pliers, & A new lamp.

Time Required: About 15 minutes.

Abstract: This guide is being published to show how easy it is to replace your original Zenith / LG 6913V00002A Lamp.

NOTE: We recommend you to use latex gloves when handling the new bulb, to avoid any dirt or oil. Our hands are naturally oily…The oil residue from our hands can cause premature failure of the lamp if the front side of the lamp is not wiped down after the installation. It doesn’t hurt to do a final wipe with a clean, non-abrasive, lint-free cloth before reinstalling your lamp…

	Zenith / LG 6913V00002A Lamp casing			1.- To get access to the inside of the enclosure, first remove the handle on the back by pulling out to the sides.
	2.- On the bottom of the enclosure there are four screws holding the lamp cover, remove them with a Phillips screwdriver.			3.- Take out the lamp cover by sliding it up from the lamp carrier.
	4.- Pull up the lamp holder 1/4", be carefull not to damage the cable connector.			5.- Remove the cable connector from the lamp carrier and take it out from the lamp holder, also remove the connector holder.
	6.-Slide out the lamp holder from the lamp carrier.			7.- Uninstall the cable on the top of the lamp by unscrewing the nut.
	8.- Disconnect the cable placed at the side of the lamp, using a Philips screwdriver.			9.- To remove the lamp holder pull out and up one side of the lamp holder.
	A.- Take out your new PHILIPS P22 UHP 100W 120W 1.0 bulb.			B.- Install your new PHILIPS P22 UHP 100W 120W 1.0 Lamp to the lamp holder.
	C.- Reinstall the cable on the side of the lamp with the screw.			D.- Reconnect the cable to the top of the lamp by tightening the nut.
	E.- Slide in the lamp holder and leave 1/4" of space for the cable connector.			F.- Reinstall the cable connector using the connector holder in the original position.
	G.- Now finish positioning the lamp holder to the bottom of the lamp carrier.			H.- Push in the lamp cover to the enclosure.
	I.- Place back the four screws to secure the lamp cover.			J.- Put the handle back to its original position, on the back of the enclosure.
	G.- And you’re finished, Congratulations.

IMPORTANT: After installing the replacement bulb, you should wipe it with a clean cloth to avoid any dirt or oil. Our hands are naturally oily…this could reduce considerably the file span of the new lamp.

Again, Discount-Merchant.com promises to be the low price leader in all Projection TV Lamps they carry…if this is not true, let us know and we’ll fix it

Click below to buy this lamp now:

Lowest Prices Anywhere!

Zenith / LG DLP Lamp 6913V00002A How-To Replacement Guide