MITSUBISHI WDV65000LP How To Guide Replacement DLP Lamp Guide

Click below to buy this lamp now:

Lowest Prices Anywhere!

Compatible TV Models: WD-65000, WD65100.

NORMAL DISCLAIMER:
— Do NOT purchase generic brand lamps such as LTI, APO or third-party manufacturers such as OSRAM. These lamps were NOT engineered with and for your TV…only your Philips lamp has been engineered to work flawlessly and output the best possible color. Above that, it just doesn’t make sense to choose an aftermarket lamp for a $5-$10 difference (and in many cases they are more expensive!!).

Be a smart consumer and shop around, do your research! Discount-Merchant.com promises to be the low price leader in all Projection Lamps they carry…if this is not true, let us know and we’ll fix it!

Tools Required: 1 Standard Philips screwdriver, 1 Pair of Pliers, & A new lamp.

Time Required: About 15 minutes.

Abstract: This guide is being published to show how easy it is to replace your original MITSUBISHI WDV65000LP Lamp.

NOTE: We recommend you to use latex gloves when handling the new bulb, to avoid any dirt or oil. Our hands are naturally oily…The oil residue from our hands can cause premature failure of the lamp if the front side of the lamp is not wiped down after the installation. It doesn’t hurt to do a final wipe with a clean, non-abrasive, lint-free cloth before reinstalling your lamp…

	Mitsubishi WDV-65000LP Lamp casing			1.- Let’s begin by removing the four screws that secure the lid from the enclosure, and then take the lid off.
	2.- Next continue with the metal cover right over the top of the bulb, in this case there is only three screws to extract.			3.- Now that the lamp is exposed you can see two cables from the connector attached to the bulb.
	4.- Use you Philips screwdriver to uninstall the screw on the side of the lamp.			5.- You’ll notice a metal piece come off once the screw is out, it is called a heat deflector, do not throw it away.
	6.- Take your pair of pliers to remove the nut on the top terminal of the lamp.			7.- Remove the last screws that secure a two clip holders, this will allow the lamp to be extracted with no problem.
	8.- Pull out the old bulb so you can replace it with the new one.			A.- Take out your new lamp that will look something like this one.
	B.-Install your new PHILIPS lamp inside the metal bulb base.			C.-Screw back the metal clips that hold the lamp in its place.
	D.- Reconnect the cable to the top of the lamp, by tightening the nut with your pair of pliers.			E.- Fasten the cable to the side of the lamp, using the Philips screwdriver.
	F.- Now the inside of the lamp will look something like this.			G.- Place the metal cover over your new lamp and reinstall the three screws.
	H.- Reinstall the lid back on with its four screws and tighten them well with the screwdriver.			I.- You have now completed the lamp replacement. Congratulations.!

IMPORTANT: After installing the replacement bulb, you should wipe it with a clean cloth to avoid any dirt or oil. Our hands are naturally oily…this could reduce considerably the life span of the new lamp.

Again, Discount-Merchant.com promises to be the low price leader in all Projection TV Lamps they carry…if this is not true, let us know and we’ll fix it

Click below to buy this lamp now:

Lowest Prices Anywhere!

Lamp MITSUBISHI WDV65000LP How-To Replacement Guide