Hitachi UX21514 How To Guide Replacement DLP TV Lamp Guide

Click below to buy this lamp now:

Lowest Prices Anywhere!

Compatible TV Models: 50VS810, 50VX915, 60VS810, 60VX915.

Assembly part numbers: NA70832, NA72192.

NORMAL DISCLAIMER:
— Do NOT purchase generic brand lamps such as LTI, APO or third-party manufacturers such as OSRAM.

These lamps were NOT engineered with and for your TV…only your Philips lamp has been engineered to work flawlessly and output the best possible color. Above that, it just doesn’t make sense to choose an aftermarket lamp for a $5-$10 difference (and in many cases they are more expensive!!). Be a smart consumer and do your research! Discount-Merchant.com promises to be the low price leader in all Projection TV Lamps they carry…if this is not true, let us know and we’ll fix it!

Tools Required: Standard Philips or Flathead screwdrivers, Pair of Pliers, A new lamp.

Time Required: About 15 minutes

Abstract: This guide is being published to show how easy it is to replace your original Hitachi Lamp UX21514.

NOTE: We recommend you to use latex gloves when handling the new bulb, to avoid any dirt or oil. Our hands are naturally oily…The oil residue from our hands can cause premature failure of the lamp if the front side of the lamp is not wiped down after the installation. It doesn’t hurt to do a final wipe with a clean, non-abrasive, lint-free cloth before reinstalling your lamp…

	1.-Hitachi DLP Lamp UX21514			2.-Start by removing the metal caseing by unscrewing it from the plastic housing.
	3.-Use the screw drive to remove the top plastic piece.			4.-Gently tug on it and pull the metal case apart from the rest of the enclosure.
	5.-Use your Philips driver to remove the metal ring holding the lamp in place.			6.-Next, remove the screw on the cable connector.
	7.-And gently pull the small metal case to remove it.			8.-Now push to the side the plastic covered cables.
	9.-Starts pulling the bulb out of the enclosure buy tilting it to the side.			10.-Now remove both cables from the lamp, with your screw driver and pliers.
	11.-Be careful for small pieces when disassembling the lamp.			12.-Grab your new bulb and re install it the same way you took out the old one.
	13.-Reconnect both cables to the new bulb and make sure they don’t move.			14.-Now place the metal ring inside on top fo the lamp, insert inside it's housing and place the screw to secure it..
	15.-When installing the cables on the side, insert the small metal guard to secure them.			16.-And place the screw to make sure it doesn’t move.
	17.-Grab the metal case that you initially took out and re install it, along with its designated screw.			18.-This is what it should look like when you're done.

IMPORTANT: After installing the replacement bulb, you should wipe it with a clean cloth to avoid any dirt or oil. Our hands are naturally oily…this could reduce considerably the life span of the new lamp.

Again, Discount-Merchant.com promises to be the low price leader in all Projection TV Lamps they carry…if this is not true, let us know and we’ll fix it!

Click below to buy this lamp now:

Lowest Prices Anywhere!

Hitachi DLP Lamp UX21514 How-To Replacement Guide