Hitachi UX21511 How To Guide Replacement DLP TV Lamp Guide

Click below to buy this lamp now:

Lowest Prices Anywhere!

Compatible TV Models: 50V500, 60V500, 60V500A, 60VX500.

Assembly part numbers: NA63991, NA72182, NT0455, NA63941.

NORMAL DISCLAIMER:
— Do NOT purchase generic brand lamps such as LTI, APO or third-party manufacturers such as OSRAM.

These lamps were NOT engineered with and for your TV…only your Philips lamp has been engineered to work flawlessly and output the best possible color. Above that, it just doesn’t make sense to choose an aftermarket lamp for a $5-$10 difference (and in many cases they are more expensive!!). Be a smart consumer and do your research! Discount-Merchant.com promises to be the low price leader in all Projection TV Lamps they carry…if this is not true, let us know and we’ll fix it!

Tools Required: Standard Philips or Flathead screwdrivers, Pair of Pliers, A new lamp.

Time Required: About 15 minutes.

Abstract: This guide is being published to show how easy it is to replace your original Hitachi Lamp UX21511.

NOTE: We recommend you to use latex gloves when handling the new bulb, to avoid any dirt or oil. Our hands are naturally oily…The oil residue from our hands can cause premature failure of the lamp if the front side of the lamp is not wiped down after the installation. It doesn’t hurt to do a final wipe with a clean, non-abrasive, lint-free cloth before reinstalling your lamp…

	1.-Hitachi DLP Lamp UX21511			2.-Start to remove the screw from the metal cage to separate it from the rest of the enclosure.
	3.-Now, gently lift it up and tug it, just a bit until its sets free.			4.-First you will need to take the screws out that are securing the cables from the plastic casing.
	5.-Now take out the screws from the metal plate that holds together the plastic casing.			6.-Take out the screws from the metal plate that holds together the plastic casing.
	7.-Split them in two until your left holding the part with the bulb.			8.-Remove the metal ring, and the bulb from the plastic housing.
	9.-You’ll notice that inside the plastic housing are two plastic pieces that hold the previous lamp, remove them.			10.-Let’s continue by removing the two cables connected to the bulb.
	11.-Ready your new Philips brand lamp that should look like this.Grab the metal ring and place it over the new lamp.			12.-Reconnect the two plastic covered cables to the new bulb.
	13.-Place the lamp inside the plastic casing; remember not to return the plastic pieces that you remove earlier.			14.-Insert the screws back on the metal ring, one on ether side.
	15.-Put together the two separated plastic casings to form the housing of the lamp.			16.-Ready your new Philips brand lamp that should look like this.Grab the metal ring and out it over the new lamp.
	17.-Place the screws to secure them tightly and firmly.			18.-Insert back the metal casing it its place.
	19.-Finally, place the last screw back, to secure the metal case.			20.-When your finish it should look like this.

IMPORTANT: After installing the replacement bulb, you should wipe it with a clean cloth to avoid any dirt or oil. Our hands are naturally oily…this could reduce considerably the life span of the new lamp.

Again, Discount-Merchant.com promises to be the low price leader in all Projection TV Lamps they carry…if this is not true, let us know and we’ll fix it!

Click below to buy this lamp now:

Lowest Prices Anywhere!

Hitachi DLP Lamp UX21511 How-To Replacement Guide