RCA-265109 How To Guide Replacement Proyector Lamp Guide

Click below to buy this lamp now:

Lowest Prices Anywhere!

Compatible TV Models: HD50THW263YX1(H), HD61THW263, HD61THW263YX1, HD61THW263YX1(H).

NORMAL DISCLAIMER:
Be a smart consumer and shop around, do your research! Discount-Merchant.com promises to be the low price leader in all Projection Lamps they carry…if this is not true, let us know and we’ll fix it!

Tools Required: Star screwdriver,Standard Philips, Flat screwdriver & A new lamp.

Time Required: About 20 minutes.

Abstract: This guide is being published to show how easy it is to replace your original RCA 265109 Lamp.

NOTE: We recommend you to use latex gloves when handling the new bulb, to avoid any dirt or oil. Our hands are naturally oily…The oil residue from our hands can cause premature failure of the lamp if the front side of the lamp is not wiped down after the installation. It doesn’t hurt to do a final wipe with a clean, non-abrasive, lint-free cloth before reinstalling your lamp…

	RCA 265109 Lamp casing			1.- First, turn the lamp upwards to remove four screws on each corner of the lamp base.
	2.- Turn the lamp to the side and punch trough the caution sticker or remove it to extract with your star screwdriver the two screws inside.			3.-After removing the top plastic cover, take the plastic cable holder from the back, lift it and push it forward slightly.
	4.- Pull the front of the bulb base carefully until it comes out completely.			5.- Take apart the plastic cable holders, remove them and make sure you don’t damage the cables.
	6.- Inside you’ll find four security clips, take a flat screwdriver to take out the two on the opposite side where the cables are connected.			7.-Be very careful when taking them out, start on one side pull it upwards then go to the other side and do the same.
	8.-Now take the bulb and slide it out from the side where there are no clips.			9.- Remove the two screws holding the cables to the bulb.
	10.- Now take out your new bare bulb to reinstall it the same way you took out the old one.			A.-Start by sliding it in where there are no clips.
	B.-Place the two clips in their respective corners by pressing firmly until you hear a clicking sound.			C.-Remember that the two clips are totally different, that also applies to the holes on each corner.
	D.- Now take the end of the cables and screw the back on to the new lamp until they can’t move.			E.-Be extra careful with the cables, make sure not to stretch them too much or else they might break.
	F.- Place back the case of the bulb, and make sure the rubber joints go in to the enclosure correctly.			G.- To assemble the plastic cable holder, you must place one of the two in; and the second one on its side, turn it slowly until they unite.
	H.- Now grab on either side and push down until it’s inserted correctly, make sure it bypasses the cable connectors without harming them.			I.-Reinstall the four screws on each corner of the bulb’s base.
	J.- Finally flip the casing to its side to insert the last screws in its place.			K.-And you’re finished.

IMPORTANT: After installing the replacement bulb, you should wipe it with a clean cloth to avoid any dirt or oil. Our hands are naturally oily…this could reduce considerably the life span of the new lamp.

Again, Discount-Merchant.com promises to be the low price leader in all Projection TV Lamps they carry…if this is not true, let us know and we’ll fix it

Click below to buy this lamp now:

Lowest Prices Anywhere!

RCA Lamp RCA-265109 How-To Replacement Guide