RCA-265103 How To Guide Replacement DLP TV Lamp Guide

Click below to buy this lamp now:

Lowest Prices Anywhere!

Compatible TV Models: HD50LPW162YX1, HD50LPW42YX3, HD61LPW162YX2(M), HD61LPW42YX4, HD50LPW162YX1(M), HD50LPW42YX4, HD61LPW163YX1(H), HDLP50W151YX2.

Assembly part numbers: 3401107, AM0000059.

NORMAL DISCLAIMER:
— Do NOT purchase generic brand lamps such as LTI, APO or third-party manufacturers such as OSRAM.

These lamps were NOT engineered with and for your TV…only your Philips lamp has been engineered to work flawlessly and output the best possible color. Above that, it just doesn’t make sense to choose an aftermarket lamp for a $5-$10 difference (and in many cases they are more expensive!!). Be a smart consumer and do your research! Discount-Merchant.com promises to be the low price leader in all Projection TV Lamps they carry…if this is not true, let us know and we’ll fix it!

Tools Required: 1 Tork T10 screwdriver (6 point star tip), 1 Tork T8 screwdriver (6 point star tip), 1 Pair of Pliers, A new lamp.

Time Required: About 15 minutes.

Abstract: This guide is being published to show how easy it is to replace your original RCA-265103 Lamp.

NOTE: The bulb should be handled with a clean lint-free cloth at all times to avoid any dirt or oil. Our hands are naturally oily…The oil residue from our hands can cause premature failure of the lamp if the front side of the lamp is not wiped down after the installation. It doesn’t hurt to do a final wipe with a clean, non-abrasive, lint-free cloth before reinstalling your lamp…

	RCA-265103 Lamp casing			1.- Start by turning the lamp casing so the bulb points to the surface.
	2.- Unclip the plastic connector holder; this can be achieved by squeezing on both sides.			3.- Use your Torx 10 screwdriver and retrieve the screw connecting the cable connected to the side of the bulb.
	4.- Now with the pair of pliers uninstall the nut placed on the top terminal of the lamp.			5.- Once the plastic connector holder is repositioned you’ll notice three lamp holders adjacent to the base.
	6.- Take your Torx T8 screwdriver to remove them one by one.			7.- Retrieve the old lamp by pulling it out.
	A.- Take out your new lamp that will look something like this one.			B.- Place the new bulb inside the lamp’s base.
	C.- Reinstall the three lamp holders securing the new bulb to the base.			D.- Reconnect the cable to the top of the lamp by tightening the nut.
	E.- Now with your Torx T10 reinsert the screw that conjoins both the side of the bulb and the cable connector.			F.- Take the connector holder and press on the sides to lock it in to place again.
	G.- And it will look something like this.			H.- And you’re finished,. Congratulations!

IMPORTANT: After installing the replacement bulb, you should wipe it with a clean cloth to avoid any dirt or oil. Our hands are naturally oily…this could reduce considerably the life span of the new lamp.

Again, Discount-Merchant.com promises to be the low price leader in all Projection TV Lamps they carry…if this is not true, let us know and we’ll fix it!

Click below to buy this lamp now:

Lowest Prices Anywhere!

RCA DLP Lamp 265103 How-To Replacement Guide