RCA-260962 How To Guide Replacement DLP TV Lamp Guide

Click below to buy this lamp now:

Lowest Prices Anywhere!

Compatible TV Models: HD50LPW162YX3, HD50LPW42, HD61LPW163YX3(H), HD61LPW42YX6, HD50LPW162YX3(M), HD50LPW42YX1, HD61LPW163YX4(H), HDLP50W151, HD50LPW162YX4.

Assembly part numbers: 3401107, AM0000059.

NORMAL DISCLAIMER:
— Do NOT purchase generic brand lamps such as LTI, APO or third-party manufacturers such as OSRAM.

These lamps were NOT engineered with and for your TV…only your Philips lamp has been engineered to work flawlessly and output the best possible color. Above that, it just doesn’t make sense to choose an aftermarket lamp for a $5-$10 difference (and in many cases they are more expensive!!). Be a smart consumer and do your research! Discount-Merchant.com promises to be the low price leader in all Projection TV Lamps they carry…if this is not true, let us know and we’ll fix it!

Tools Required: 1 Tork T10 screwdriver (6 point star tip), 1 Tork T8 screwdriver (6 point star tip), 1 Pair of Pliers, A new lamp.

Time Required: About 15 minutes.

Abstract: This guide is being published to show how easy it is to replace your original RCA-260962 Lamp.

NOTE: The bulb should be handled with a clean lint-free cloth at all times to avoid any dirt or oil. Our hands are naturally oily…The oil residue from our hands can cause premature failure of the lamp if the front side of the lamp is not wiped down after the installation. It doesn’t hurt to do a final wipe with a clean, non-abrasive, lint-free cloth before reinstalling your lamp…

	RCA-260962 Lamp casing			1.- Let’s begin by flipping over the lamp casing upside down.
	2.- Unlock the plastic connector holder by pressing the sides of it and place it to the side of the lamp.			3.- Unscrew the cable connected to the side of the lamp. Using a Tork T10 screwdriver.
	4.- With the pair of pliers remove the nut on the top of the lamp.			5.- Remove the plastic connector holder, so you will have complete acces to the lamp holders located at the base of the lamp.
	6.- Remove the three screws from the metal holders, using a Tork T8 screwdriver.			7.- Remove your old lamp, by pulling it out.
	A.- After removing your old bulb take out your new one, wich will look something like this.			B.- Place your new PHILIPS E23 UHP 100W 1.3 lamp.
	C.- Place back the three lamp holders using a Tork T8 screwdriver.			D.- Reconnect the cable to the top of the lamp by tightening the nut.
	E.- Reinstall the cable on the side of the lamp with a Tork T10 screwdriver.			F.- Lock again the plastic connector holder by pressing on the sides and placing back the holders to their original position.
	G.- So it will look like this.			H.- And you’re finished,. Congratulations!

IMPORTANT: After installing the replacement bulb, you should wipe it with a clean cloth to avoid any dirt or oil. Our hands are naturally oily…this could reduce considerably the life span of the new lamp.

Again, Discount-Merchant.com promises to be the low price leader in all Projection TV Lamps they carry…if this is not true, let us know and we’ll fix it!

Click below to buy this lamp now:

Lowest Prices Anywhere!

RCA DLP Lamp 260962 How-To Replacement Guide