MITSUBISHI 915P026A10 How To Guide Replacement DLP Lamp Guide

Click below to buy this lamp now:

Lowest Prices Anywhere!

Compatible TV Models: WD-52627, WD-52628, WD-62627, WD-62628.

Assembly part numbers: 2930245, 2930246, AM0000112.

NORMAL DISCLAIMER:
— Do NOT purchase generic brand lamps such as LTI, APO or third-party manufacturers such as OSRAM. These lamps were NOT engineered with and for your TV…only your Philips lamp has been engineered to work flawlessly and output the best possible color. Above that, it just doesn’t make sense to choose an aftermarket lamp for a $5-$10 difference (and in many cases they are more expensive!!).

Be a smart consumer and shop around, do your research! Discount-Merchant.com promises to be the low price leader in all Projection Lamps they carry…if this is not true, let us know and we’ll fix it!

Tools Required: 1 Standard Philips screwdriver, 1 Pair of Pliers, & A new lamp.

Time Required: About 15 minutes.

Abstract: This guide is being published to show how easy it is to replace your original MITSUBISHI 915P026A10 Lamp.

NOTE: We recommend you to use latex gloves when handling the new bulb, to avoid any dirt or oil. Our hands are naturally oily…The oil residue from our hands can cause premature failure of the lamp if the front side of the lamp is not wiped down after the installation. It doesn’t hurt to do a final wipe with a clean, non-abrasive, lint-free cloth before reinstalling your lamp…

	Mitsubishi 269343 Lamp casing			1.- First, locate two screws on the back of the lamp that are holding the lamp cover.
	2.- Remove booth screws.			3.- Once booth of them are removed, take out the lamp cover.
	4.- Using a Philips screwdriver disconnect the cable placed at the side of the lamp.			5.- Unscrew the nut in the top of the lamp to separate the cable form the bulb.
	6.- On the base of the lamp, there are three lamp holders, remove them with a Phillips screwdriver.			7.- Uninstall the metal clip located under the connector holder, using a Phillips screwdriver.
	8.- Remove your old lamp, by pulling it out.			A.- After removing your old bulb take out your new one, wich will look something like this.
	B.-Install your new PHILIPS E22 UHP 100W/120W 1.0 lamp inside the lamp holder.			C.-Reinstall the metal clip to the back of the lamp, using your Phillips screwdriver.
	D.- Install again the three metal holders to the bottom of the lamp.			E.- Reconnect the cable on the side of the lamp with the screw.
	F.- Conjoin the cable to the top of the lamp by tightening the nut.			G.- Reinstall the lamp cover to the lamp enclosure.
	H.- Place back the two screws to the back of the lamp cover.			I.- And you’re finished, Congratulations!

IMPORTANT: After installing the replacement bulb, you should wipe it with a clean cloth to avoid any dirt or oil. Our hands are naturally oily…this could reduce considerably the life span of the new lamp.

Again, Discount-Merchant.com promises to be the low price leader in all Projection TV Lamps they carry…if this is not true, let us know and we’ll fix it

Click below to buy this lamp now:

Lowest Prices Anywhere!

Lamp MITSUBISHI 915P026A10 How-To Replacement Guide