Hitachi UX21517 How To Guide Replacement DLP TV Lamp Guide

Click below to buy this lamp now:

Lowest Prices Anywhere!

Compatible TV Models: 50V720.

Assembly part numbers: NA63991, NA72182, NT0455, NA63941.

NORMAL DISCLAIMER:
— Do NOT purchase generic brand lamps such as LTI, APO or third-party manufacturers such as OSRAM.

These lamps were NOT engineered with and for your TV…only your Philips lamp has been engineered to work flawlessly and output the best possible color. Above that, it just doesn’t make sense to choose an aftermarket lamp for a $5-$10 difference (and in many cases they are more expensive!!). Be a smart consumer and do your research! Discount-Merchant.com promises to be the low price leader in all Projection TV Lamps they carry…if this is not true, let us know and we’ll fix it!

Tools Required: Standard Philips or Flathead screwdrivers, Pair of Pliers, A new lamp.

Time Required: About 15 minutes

Abstract: This guide is being published to show how easy it is to replace your original Hitachi Lamp UX21517.

NOTE: We recommend you to use latex gloves when handling the new bulb, to avoid any dirt or oil. Our hands are naturally oily…The oil residue from our hands can cause premature failure of the lamp if the front side of the lamp is not wiped down after the installation. It doesn’t hurt to do a final wipe with a clean, non-abrasive, lint-free cloth before reinstalling your lamp…

	1.-Hitachi DLP Lamp UX21517			2.-With the screwdriver remove the metal casing from the rest of the unit.
	3.-Lift it up carefully, and then give it a small tug.			4.-Now, start removing the screws holding the cables to the plastic casing.
	5.-Next, remove the screws that secure the metal ring to the lamp.			6.-Continue with the ones holding a metal piece that binds together the plastic enclosement.
	7.-Take apart the two pieces, and keep the one with the lamp inside.			8.-Take off the metal ring from the bulb, and remove both until your left with the plastic base.
	9.-If you look inside you’ll notice two serpent pieces, remove them, you won’t need them anymore.			10.-Let’s continue by removing the two plastic covered cables connected to the bulb.
	11.-Ready your new Philips brand lamp that should look like this.Grab the metal ring and place it over the new lamp.			12.-Reconnect both cables to the new lamp and make sure they don’t move.
	13.-Insert the metal ring back on the lamp and place both back to the plastic base.			14.-Tighten well both screws on either side, and make sure it doesn’t move.
	15.-Reassemble the two plastic casings back together.			16.-Secure well the screws on the small metal plate.
	17.-And then the ones that hold together the two cables and the casing.			18.-Place the metal cage back and make sure it stays in place.
	19.-Finish by incerting the screw back on the metal cage so it doesn’t move.			20.-Finally this is what it looks like when you’re finished.

IMPORTANT: After installing the replacement bulb, you should wipe it with a clean cloth to avoid any dirt or oil. Our hands are naturally oily…this could reduce considerably the life span of the new lamp.

Again, Discount-Merchant.com promises to be the low price leader in all Projection TV Lamps they carry…if this is not true, let us know and we’ll fix it!

Click below to buy this lamp now:

Lowest Prices Anywhere!

Hitachi DLP Lamp UX21517 How-To Replacement Guide